|
看看这个review,弹壳拔不出来好像是普遍问题唉
The bolt face seemed to be machined out of spec. When a live round was chambered it was not possible to extract the round, as the bolt would lock into the chamber and would rotate to the point that it would not move. The charging handle could not be pulled. The only way to unlock the bolt was to fully seperate the lower and upper recievers, and then use a flathead screwdriver to pry the bolt away from the chamber. This all had to be done with a live round chambered. No amount of lube would allow the free movement of the bolt once locked. I completely took apart the bolt and BCG, cleaned, lubed and put it back together to no avail. I even removed the bolt spring and tried that, and then tried putting the bolt spring on upside-down, all to no avail. This overlook on QC caused a fairly significant safety hazard to the operator. It would not be possible to remove a round in a situation where your wellbeing was put into question. If you tried to fire a round and it would not fire, you could not remove the defective round in an immediate action response. This failure of QC will dissuade me from buying any other Adams Arms products again. My attempts to contact Adams Arms went unaswered. Please be vigilant if you decide to purchase this product, conduct a full safety inspection prior to use.
|
|