sig sauer customer service 关于break in的回复。

wrd

回复注明 “[size=13.600000381469727px]This is my normal break in procedure. ” 表明仅代表个人观点，与sig sauer立场无关？呵呵。问他可不可以用CLP, 回答是不推荐，可能会伤finish.

This is my normal break in procedure.

Equipment Required:

A. Quality one piece coated or graphite cleaning rod with a good bearing.

B. Nylon bore brush, jag and patches of the correct caliber.

C. A good quality bore solvent such as Butch’s Bore Shine, Shooters Choice, or Montana Extreme.

D. JB Bore Bright.

E. 40 rounds of ammunition.

Intermediate Task A


1. Clean the barrel, to remove fouling from proof rounds.

a. Soak a patch in bore cleaner and run through the bore.

b. Leave in the bore for about 5-10 minutes to allow solvent to work on residue.

c. With a solvent soaked brush scrub the bore 12 -15 strokes.

d. Run a solvent soaked patch through the bore.

e. Blue coloration on the patch indicates copper.

f. Repeat until the barrel is free of copper.

g. Dry the barrel with clean patches.

h. Take a patch and coat it with JB Bore Bright. Rub it in with your fingers until it is completely covered.

i. Wrap it around a nylon bore brush.

j. Follow the direction on the Bore Bright and scrub the barrel. The patch will come out black.

k. Remove any residue with bore cleaner and dry patches.

Intermediate Task B

Firing Sequence

1. Shoot one (1) round followed by cleaning. Repeat this five (5) times for a total of five (5)    rounds.

2. Shoot two (2) rounds followed by cleaning. Repeat this five (5) times for a total of ten (10) rounds.

3. Shoot five (5) rounds followed by cleaning. Repeat this five (5) times for a total of twenty five (25) rounds. Rifle will now have a total of forty (40) rounds through the barrel.

wrd

xinxin19 发表于 2013-11-22 20:08
真够累的...话说拿来之前不都被test fire了几发么。

是够累的，看着都累。

wrd

akula 发表于 2013-11-22 21:04
不上几张图片？

回头和靶纸一起上吧。

wrd

HOUSCOUS 发表于 2013-11-22 22:33
这个是rifle的break in procedure， 手枪的还好。

手枪打得准不准，人的因素远远大于枪的吧。break in就算真的对精度有影响，应该可以忽略不计了。