|
|
本帖最后由 StarFox000 于 2022-1-25 20:09 编辑
额滴神呀 请这位大侠看完结论再说好不好 超声波清洗会让铝制罐掉漆并对铭刻不友善但不影响质量和使用
Sonic Cleaners & Suppressors
https://www.silencershop.com/blog/post/sonic-cleaners-suppressors
This time around, we started to see some minor damage to the finish - so we decided it would be a good idea to limit the time that finished parts spend in the sonic cleaner. Unfortunately, the lesson we should have learned was to leave the finished parts completely out!Our third test was the first time we really started to see good cleaning results. This time we used an AAC Element and followed these steps:- Put only the internal baffles into the sonic cleaner for 15 minutes.
- Pulled them out and gently scrubbed them using a copper brush - the carbon pieces flecked off far easier than normal so we only spent a couple of minutes and didn't worry about getting it perfect.
- Put the baffles back into the sonic cleaner together with the tube for an additional 15 minutes.
- After the second 15 minute run, the remaining build-up fell off easily and they looked great! Literally, the baffles looked like new!
Unfortunately, although we only put the tube in for 15 minutes, it didn't fare well at all.This is the kind of thing that would make you sick if you had just spent the time and money to procure a nice new suppressor; so, once again, I advise you to leave the finished parts completely out of the sonic cleaner!Regardless of the damage to the Element finish, we continued with our experiments since we were impressed with how clean the baffles were coming out. Since we have heard so much about how aluminum parts may or may not be damaged in a sonic cleaner, we decided to give that a try using a, fully aluminum, Tactical Innovations Stratus suppressor. Since the Hornady gun cleaning solution is supposed to be safe for aluminum parts, we didn't anticipate any problems - but we hadn't anticipated the finish coming off either...Fortunately, the Stratus came out as clean as the Element - and with no pitting or other damage to the aluminum baffles. I'm not going to guarantee anything; but, we're not going to worry about aluminum baffles going into the sonic cleaner.Overall, I think this is a great tool for cleaning the baffles from take-apart cans since they come out perfectly clean with a minimum of effort. It is unfortunate that the finish can be damaged so easily since that makes it impossible to just throw a sealed can into the sonic cleaner every few thousand rounds. For sealed cans, I think we'll just stick with soaking in solvent and rinsing them out.
|
|
楼主
发表于 2022-1-25 18:38
